Bytte eller rengjøre innsugsfilter

BigTwin
Post Reply
User avatar
poppeyau
Posts: 18
Joined: 11 Jun 2010, 02:26

Bytte eller rengjøre innsugsfilter

Post by poppeyau »

Hei
Ser i manauelen til min 2007 Dyna at innsugsfilteret skal rengjøres i lett fettløsende såpevann. Hva gjør dere, rengjør eller bytter?
User avatar
DaddyCool
Posts: 755
Joined: 09 Mar 2010, 18:30

Re: Bytte eller rengjøre innsugsfilter

Post by DaddyCool »

Det er jo mange som bytter til et annet filter, men problemstillingen kommer uansett opp til slutt. Hvis du ikke skal gå over til et annet filter er det ingenting i veien for å rengjøre det. Eventuellt så ville jeg selv byttet til ett bedre filter enn det orginale, motoren bør få mer luft.
Male masculine icon...athletic godlike clone
User avatar
Hydrashovel
Posts: 13
Joined: 10 Mar 2010, 00:54

Re: Bytte eller rengjøre innsugsfilter

Post by Hydrashovel »

skal det ikke settes inn med olje også?
If it doesn't fit, force it! If it breaks it needed replacement anyway....
User avatar
Coldman
Posts: 1229
Joined: 08 Mar 2010, 13:05

Re: Bytte eller rengjøre innsugsfilter

Post by Coldman »

Hydrashovel wrote:skal det ikke settes inn med olje også?
Nei.

Fra service-manualen (står også det samme i brukermanualen):
6. Clean filter element.
a. Wash the paper/wire mesh air filter element and
breather tubes in lukewarm water with a mild detergent.
Do not strike filter element on a hard surface to
dislodge dirt.
b. Allow filter to either air dry or blow it dry, from the
inside, with low pressure air. Do NOT use air cleaner
filter oil on the Harley-Davidson paper/wire mesh air
filter element.

c. Hold the filter element up to a strong light source. If
light is uniformly visible through the element, it is
sufficiently clean.

Og for SE-filteret:
MAINTENANCE
Air Cleaner Element Maintenance
NOTES
This is a dry air filter. Do not apply oil to the filter element.
When servicing the air cleaner, apply Loctite 243 (blue) to
threads of all fasteners.
1. See Figure 1. Remove air cleaner cover (B) and inspect
the filter element (7) every 5000 mi (8000 km), or more
often under dusty conditions.
2. Clean filter element as follows:
a. Remove and wash element by immersing it, on edge,
in a shallow pan containing enough Air
Cleaner/Degreaser to cover no more than 3/4 the
depth of the filter pleats. Do not let dirty solution get
inside the element. Carefully "roll" the element in the
solution around its perimeter until the entire outer
surface of the filter pleats has been soaked.
b. Remove filter element from cleaner/degreaser and
allow five minutes for the cleaner to dissolve the dirt.
c. From the inside out, rinse the element with cold water.
Shake off excess water, and allow the element to air
dry. Do not dry with compressed air.
3. Install air cleaner element and cover
Coldman
2008 Dyna Street Bob FXDB
1956 Harley FL 621 Chopper
User avatar
Hydrashovel
Posts: 13
Joined: 10 Mar 2010, 00:54

Re: Bytte eller rengjøre innsugsfilter

Post by Hydrashovel »

okei...jeg har ikke papirfilter Sturla
If it doesn't fit, force it! If it breaks it needed replacement anyway....
User avatar
Coldman
Posts: 1229
Joined: 08 Mar 2010, 13:05

Re: Bytte eller rengjøre innsugsfilter

Post by Coldman »

Hydrashovel wrote:okei...jeg har ikke papirfilter Sturla
Nei, svaret mitt var selvfølgelig ment for trådstarter med en 2007 Dyna og gjelder originalfilter og se-filter. :)

Ofte (men sikkert ikke alltid) står det "DO NOT OIL" på filtre som ikke skal ha olje.
Coldman
2008 Dyna Street Bob FXDB
1956 Harley FL 621 Chopper
User avatar
Hydrashovel
Posts: 13
Joined: 10 Mar 2010, 00:54

Re: Bytte eller rengjøre innsugsfilter

Post by Hydrashovel »

jeg ble vel bare litt overasket ettersom jeg aldri har rengjort et papirfilter Sturla, jeg pleide å kaste dem når de ble skitne....var igrunnen ikke klar over at det er vanlig.......
If it doesn't fit, force it! If it breaks it needed replacement anyway....
Post Reply

Return to “Diverse teknisk”